Saturday, February 3, 2024

Storing Pipe Clamps

 Ever since that table project, I've had pipe clamps laying on the floor of the garage, and when it rains, everything is covered in water.  I needed to get them off of the floor.  I used a 2x4 for each end, and I used another one to create the braces to screw that too the wall.  I bored them out using a 1-1/4" Forstner bit, and then finished the cuts for one side (I left the complete hole on the second end).

Bolted them to the wall.

Now, my clamps are off the floor!

No comments:

Post a Comment